DIY Iron On Transfer Be More Pippi Quote | Pippi Longstocking | Various colors & sizes available #textiledesign
Share on Facebook Share on Pinterest Share on Twitter

DIY Iron On Transfer Be More Pippi Quote | Pippi Longstocking | Various colors & sizes available #textiledesign



DIY Iron On Transfer Be More Pippi Quote Pippi von PaperCandyNL

Funny DIY Iron On Transfer with Pippi Longstocking with quote. Iron on transfers are a stylish and fun way to decorate your textile or fabrics, like t-shirts, hoodies, cushions, canvas totes etc. Various colors & sizes available. Also custom made design available. Small - 10x14 cm - 3.9x5.5 inch Medium - 14.5x20 cm - 5.7x7.9 inch Large - 21x29 cm - 8.3x11.4 inch ATTENTION! We offer several colors, however especially for this design, for best results, the printing material should be lighter in color than the color of the application! We will send, at your request, gladly an example so you can see how the chosen color to your color textile suits. Please let us know which color your fabric is and we send a sample by mail to avoid disappointment. If you have already paid and you are not satisfied with the sample that was sent and not choose a different color, your payment will be returned asap. If you did not request for a sample, possible in the comments area, we are not liable if application on design is disappointing. How to Iron-on: Apply to cotton, polyester or a mixture thereof. Washable at 40ºCelsius. Never iron directly on the application. The average press time is about 18-25 sec. at 160-170 degrees. [Between wool and cotton in position, two dots = 150ºC, three dots = 200ºC] New fabric ALWAYS pre-ironing to remove the factory coating and dust, before you begin with the design. Remove the sheet of tissue paper without pulling along the motive. Place the fabric to be printed on a hard, flat surface. Install the application to the desired position with the transparent heat-resistant foil upwards. Place on top of that the baking paper. Put the iron on the design and press [with some body pressure] approximately 18-25 seconds on the design. Read the instructions below. Furthermore, it is important to not move the iron during ironing !!!! You should also consider the fact that if you have a steam iron the steam must be turned OFF, and the holes in the soleplate provide worse results than with a smooth soleplate. At the place of the steam vents there is no pressure so the iron has to be moved several times in order to ensure that the entire design can adhere. If the transfer layer is a bit cooled down (you may remove it while hot, but be carefull for burns) then remove it carefully. If the application is not attached properly to the surface, repeat the process again. Applying the foil is possible with an iron but you should be aware that the quality can never be the same as using a professional heat press. It is therefore wise to try on a sample piece to avoid disappointment from this first. We are not responsible for the incorrect installation of the application. IDEAS: T-shirt Baby Onesies Hoodies Pillow case Tote Bag Also nice for [kids]party's! We also make custom iron-on applications, design your own. We are not liable for any copyright. We also professionally printing fabric with a heat press. See shop section "Shirts & Bags".

journey